磨刀机操作方法注意
1.磨刀机在磨削刀具时需要控制好砂轮压力,刀具的再次加磨使用,如果受到不均匀的压力容易出现刀具刃口偏磨,刀片刀刃各部分的锋利程度不同,否则在摆动刀片的时候可能会出现刀刃之中有凸起。
2.刀刃部位的研磨速度不可过快,否则研磨剂容易被挤压和高速旋转给刮掉,不能够起到研磨过程中应有的润滑效果,锋利的刀齿容易被打断。
3.大型磨刀机必须磨削中大型刀具,如果行程不够,首先刀具不能得到充分的往复磨削,所以,必须磨中大型刀具,有足够的磨削行程时才建议使用此类磨刀机。
4.同一把刀不可单方面希望其精度更高,而减小每次的进给量,从原本的适量少次变为少量多次,这样刀具持续性处于磨削加工的高温当中,退火及变形的问题很容易发生。
产品英文详情介绍
note 1. grinder grinder operation during grinding wheel tool need to control the pressure, plus the grinding tool used again, if subjected to uneven pressure tool edge prone to uneven wear, sharpness of blade cutting edge portions different, or it may occur when the swinging blade in a raised edge. 2. the edge portion of polishing rate is not too fast, or the abrasive can easily be pressed and rotated at high speed to scrape the grinding process can not be played due lubricating effect, sharp teeth likely to be interrupted. 3. large grinder when grinding large tools must, if the trip is not enough, the first tool can not be fully reciprocating grinding, therefore, must wear in large tools, there is enough grinding stroke is recommended to use such grinder . 4. the knife is not the same unilaterally desired higher precision, while each of the feed decreases, the fewer times the original amount becomes small portions, so that the tool at a high temperature continuous grinding them, and annealing deformation problems are likely to occur.
东台市柯尔柏机电设备有限公司
17849497921
qq: 3416894509